Kastas Sealing Technologies
Firma
   
Language Selection
Informazioni Tecniche
Hydraulic Sealing Elements
Pneumatic Sealing Elements
Working Principle of Sealing Elements
Surface Roughness
System Tolerances And Designs
Choosing Sealing Elements
Guide Elements
O’rings
General Installation Information
Storage Conditions
  
/ Informazioni Tecniche / Pneumatic Sealing Elements / Choosing Sealing Elements
Choosing Sealing Elements
CHOOSING SEALING ELEMENTS
System pressure, sliding speed, temperature, media, surface roughness and system tolerances are the important parameters when choosing the type of the pneumatic sealing element..
PRESSURE   TEMPERATURE
The pressure does not go beyond 16 bar (special applications only) in pneumatic systems. That is why the pressure source (air compressors, etc) settings are between 3 to 8 bar. The expectation from the pneumatic sealing element is to function properly with no interruption in low pressures..   Operating temperature and local temperature increasement due to the friction forces should be taken into consideration when choosing the sealing elements in pneumatic systems. For high temperature applications sealing elements can be used from PTFE and FKM.
SPEED   AIR
Pneumatic systems increasingly being used in automation processes and requires high sliding speed. The speeds (0.5 m/sec and higher) are generally higher than the hydraulic applications and these are named medium speeds in pneumatics. The negative effects of the friction forces cause by high sliding speed should be taken into consideration when choosing the material and profile to have the optimum sealing in the system   Generally, the compressed air contains dust, dirt and moisture if no prior operation is applied on it. Life span of the sealing element shortens under this operating condition. That is why filters should be used in order to purify the air from the compressor oil and to clean the air. Maximum cleanliness is essential before greasing and commissioning; the system must be completely free from machining residue, old lubricants and any other contaminations. Prepared compressed air should be used as dried or conditioned with special lubricants. Special assembly grease should be used for the sealing elements that will be working in non oiled systems in order to have optimum friction forces.

 

 

 





 






Privacy Policy
Azienda
Informazioni Relative a Kastas
R&D
Capacità Produttiva
Gestione Qualità
Vendite e Logistica
Responsabilità Aziendale
Carriera
Prodotti
Tenute Idrauliche
Guarnizioni Pneumatiche
Elementi di Guida
Elementi di Tenuta Statici
Elementi di Guida Speciali
SmartSeal Custom-Made Machined Seals
Settori Industriali
Macchine Agricole
Macchine da Costruzione
Presse Idrauliche
Idraulica Mobile
Industria Mineraria
Metal Processing
Plastic Injection Moulding Machines
Informazioni Tecniche
Hydraulic Sealing Elements
Pneumatic Sealing Elements
Guide Elements
O’rings
General Installation Information
Storage Conditions
News & Video
News
Eventi & Fiere
Download
Video
Kastas Zoom
Newsletter
Contatto
Sede
Kastas Europe GmbH
Filiali
Distributori
Modulo Contatto
© All rights reserved 2022
Asersoft